Belt Adjustment - HOMCOM A90-208V90 Instructions Manual

8. Usage Of Silicone Oil

9. Belt Adjustment

(1) Running belt deviates to left
Start the machine with speed 1-3KM/H (Don't stand on machine). Use the Allen wrench to turn
the screw clockwise until desired fitted (see fig1). Then let the machine run without loading for 1-2
minutes. Please adjust like this until the belt is in the middle.
(2) Running belt deviates to right
Start the machine at speed 1-3KM/H (Don't stand on machine). Use the Allen wrench to turn
the screw counterclockwise until desired fitted (see fig2). Then let the machine run without loading
for 1-2 minutes. Please adjust like this until the belt is in the middle.
(3) Running belt stuck
If the running belt is not moving, use the Allen wrench to turn the screws 180 degrees on both
left and right sides until this is solved (see fig3).
Pull up tightly of the running belt. Then apply the silicone oil to
the running board. Start the machine and let it run for 3 minutes
without using. It is recommended to do this after every 30 hours of
use. It will extend the lifetime of running belt.
8