Display Monitor - HOMCOM A90-208V90 Instructions Manual

6. Display Monitor

(1) Display
1.1 " TIME " window has two modes which shows the running time. Forward counting
time is from 0:00 to 99:59 minutes.
(setting range: 5:00~99:00 minutes). The machine will stop slowly when it counts to
0:00 and shows "end", then the machine will come to the standby mode after 5
seconds.
" STEP" window shows the steps. It counts from 0 to 9999 steps. It will recount
when the step number reaches the top point.
Note: The window will be switched from TIME and STEP cyclically, you can
press " M " button to switch between cyclic display mode and single disp lay
mode in motion state.
1.2 " DISTANCE " window has two modes which shows the current movement distance.
In the forward counting mode, the distance will be increased from 0.0 to 99.9 miles,
it will recount if the distance reaches the top point. In the distance countdown
mode, the distance will be decreased from the setting data (setting
range:1.00~99.00miles) to 0. The machine will stop slowly when it counts to 0:00
and shows "end", then the machine will come to the standby mode after 5 seconds.
"CALORIES " window has two modes which shows the calories. Forward mode
counts from 0 to 9999, it will recount when it reaches the top point. Countdown
mode will count from setting calorie data (setting ranges 20~990) to 0. The machine
will stop slowly when it counts to 0:00 and shows "end", then the machine will come
to the standby mode after 5 seconds.
Note: The window will be switched from DISTANCE and CALORIES cyclically,
you can press " M" button to switch between cyclic display mode and single
display mode in motion state.
1.3 "SPEED" window shows the current running speed, the setting range is
1.0km/h~10km/h. The speed will +/- 0.1km/h every time you click "+/-"
button. P1 ~ P12 are displayed under the setting of automatic selection.
Countdown is count to 0 from the set time
4