Daily Maintenance; Troubleshooting - HOMCOM A90-208V90 Instructions Manual

10. Daily Maintenance

1. Please switch off and unplug from power outlet before checking the machine or clearance.
2. Clean belt and dial plate after use, at least once every week.
3. Do not hang up clothes, etc. on the machine.
11. Trouble Shooting
Error
Meaning
Code
No Safety key on
Err(or E00)
Panel
E2 Control Board Error
E4 Control Board Error
Over
E5
current Protection
E6 Motor Error
Communication
E7
Failures
E8 Overload Protection
Problems
Safety key is not on the
panel or it is not properly
put on
Control board is broken
or pseudo soldering on
control board
Control board is broken
Control board short
circuit or motor blocked
Motor broken or motor
line fall off
Wires from the control
board to panel board are
broken or not properly
connected
Excess of electricity or
user exceeded max load
weight
9
Solutions
1. Put safety key in the yellow area of
panel
2. Err(or E00) still shows or there is no
function, change the computer
screen/display monitor.
Replace control board
Replace control board
1. Open the motor cover and check
whether the motor is blocked. Remove
the block if yes.
2. Replace the control board if it's not
blocked or the error still shows.
1. Open the motor cover and check
whether the motor is broken or whether
the motor wire is connected to control
board properly. Reconnect the wire is
recommended.
2. Replace the control board if the error
still shows.
1. Make sure the wires from the control
board and panel board are connected
securely and not damaged.
2. Replace the control board if the error
still shows.
1. Make sure the user does not exceed
max weight capacity.
2. Reconnect power and re-start the
machine.
3. Replace the control board if the error
code still shows.