Functional Instruction - HOMCOM A90-208V90 Instructions Manual

1.4 After the treadmill is started, every window will be displayed cyclically at an interval
of 5 seconds. You can press the "M" button to switch between cyclic display mode
and single display mode.
1.5 The maximum speed of the treadmill will be limited to 6km/h when the dashboard
deflected from a horizontal direction to an arbitrary direction by more than 60
degrees .
(2) Function Of The Remote Control
2.1 "Start/Stop":
(1) In standby or countdown mode: Press "start/stop" button to start the machine.
Please note that the default speed is 0.5mph.
(2) Choose the preset program: Press "start/stop" to start the machine and the speed
will changes according to the preset speed.
(3) In running state: Press "start/stop", then the treadmill will stop slowly and back to
standby state.
2.2 "+" "-" button is to adjust speed. Keep pressing "+"/ "-" over 0.5 seconds, the speed
will keep increasing or decreasing. Please note the speed will change by 0.1km.
2.3 "M": In standby mode: it can switch from different mode, including Time, Distance
and Calories. In running mode: press "M" button will switch display mode between
cyclic display mode and single display mode.
2.4 "P": There are P1~P12, totally 12 preset programs you can choose when in
standby mode.
2.5 "Reset": Press the "Reset" button, the treadmill will stop immediately. And the
system will restart.
REMARK: Any valid pressing, the treadmills will make a sound "Bi".

(3) Functional Instruction

3.1 Sports mode: Press "start" button to start the machine and the SPEED window will
count from "3 2 1". Please note that the default speed is 1.0KM and you can press "+""-"
to adjust speed.
3.2 Countdown mode: when in standby, press "M" button to choose countdown for time,
distance and calories. Press "+" "-" to set relevant data. After setting, press "start/stop"
to start the treadmill, it will count down from the set data, the machine will stop by itself
when it counts to 0.
3.3 Preset program(P01~P12): choose one program first and then press "+""-" to set the
5