Functional Test - M-LOCKS Tantum Basic Mounting Instructions

Connect a 9V alkaline Procell, Duracell , Energizer or Duracell Industrial battery to the battery clip to the
keyboard (or battery box) , and check the lock functions .
Please lay the cables in such a way that they are not kinked, that the cables are not crushed and that
there is no friction with moving parts of the boltwork.
When installing the cable, make sure that the connecting cable has enough space between the lock and
moving parts. We recommend a distance of at least 5 mm and a fixation of the connecting cables e.g.
by means of cable ties.
If the distance between the cable and the lock is too small, the manufacturer (M-LOCKS) can provide
you with special M6 spacer bolts (increase the distance by 6 mm) or longer M6 / polyamide-coated
fastening screws.
When using longer fastening screws, it is possible to independently increase the distance (lock / bolt-
work) using metal spacer washers / bushings.
In this case, please ensure that the fastening screws still have sufficient engagement with the fasten-
ing points of the boltwork.
6

FUNCTIONAL TEST

As with all locks from M-LOCKS, this unit has a unique feature for checking the electronics (both that
of the input unit and that of the lock): 'Function 5'.
Press and hold key '5' until you hear a double tone. The LED will illuminate when performing the
following actions:
5
Next, press all of the keys in one by one and one after the other.
1 2 3 4
If the key = OK
If the key = not OK , the test will be aborted.
If one or more keys do not operate properly, please contact your supplier.
Perform this functional test always with door open!
Functional test
• Enter code. The lock emits a double signal for the correct code.
• When the lock bolt is fully retracted turn bolt work handle towards OPEN position.
• Turn handle towards LOCKED position.
• In case the lock is programmed with Push to Close, push a random digit on the keypad. The lock
should close now.
• In case the lock is programmed to close automatically the lock should close as soon as the bolt work
is in the fully closed position (signalled by a door/ bolt work switch).
• Make sure there is an air space on all sides of the lock bolt when the safe's bolt work is fully thrown
into locked position.
6
5 6 7 8 9 0
www.m-locks.com