Advertisement
Table of Contents
Technical manual
Mounting Instructions
T6530 with blue foil keys
T6530 DL with Dallas reader and blue foil keys
T6530 B with black foil keys
T6530 DLB with Dallas reader and black foil keys
Optional for use with Straightbolt locks:
T9090 turnable backplate
DIMENSIONS
The terminal for the electronic key (Dallas Key) is located in the front, over the keypad (only models
T6530 DL and T6530 DLB).
1. STATIONARY MOUNTING
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must be
deburred well to avoid damage to the cable.
Lift the pad so that you can see mounting holes.
-
Let lock's connecting cable pass through the hole on safe's door.
-
Insert and fix the two inbus screws, paying attention to cables, they have not to be squashed
-
by housing and let battery cables have easy access.
Drill (3,5 mm) the screw heads so that tools don't work for dismounting (due to EN1300)
-
Clean the keypad surface.
Remove adhesive film from pad and line up margins carefully, before fixing it.
M-LOCKS BV
Vlijtstraat 40
NL-7005 BN Doetinchem
Fixing of the input pad:
ver. 1.2 2011 10 21
1
T6530
1 Stationary
2 Turnable
Tel: +31 (0)314 376 876
Fax: +31 (0)314 376 878
www.m-locks.com
Advertisement
Table of Contents
Related Manuals for M-LOCKS T6530
Summary of Contents for M-LOCKS T6530
- Page 1 T6530 Technical manual Mounting Instructions T6530 with blue foil keys T6530 DL with Dallas reader and blue foil keys T6530 B with black foil keys T6530 DLB with Dallas reader and black foil keys Optional for use with Straightbolt locks:...
- Page 2 T6530 2. TURNABLE ENTRY UNIT only with T9090 The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must be deburred well to avoid damage to the cable. Prepare the mounting and cable holes according to picture Hold the bearing plate in a way against the mounting surface that “UP”...
Need help?
Do you have a question about the T6530 and is the answer not in the manual?
Questions and answers