Shadowspec UNITY OCTAGON DUO Owner's Manual page 19

POSITIONING AND CONNECTING THE SMART BATTERY
Step 1 Slide the fully charged SS-1 Smart Battery onto the Main Spar at the LED-light end.
Step 2 Plug the LED Light into the SS-1 Smart Battery (push in all the way, ensuring a waterproof connection).
Step 3 See the SS-1 Bluetooth LED Battery and Charger manual for software installation and Bluetooth Smart
Battery pairing - this manual comes with the SS-1 Bluetooth LED Battery and Charger.
Step 4 To remove the SS-1 Smart Battery first disconnect it from the LED Light, THEN slide the battery back to release
the hooks from the key-slots. See
NOTE:
Please contact us if you would like to purchase an optional Smart Battery and Charger(s).
Figure 22 - Plugging in the SS-1 Smart Battery
RECHARGEABLE SMART BATTERY CARE AND RULES FOR USE
• Only use the Shadowspec Charging Adapter to charge the Shadowspec SS-1 Bluetooth LED Smart Battery.
• Please charge your SS-1 Smart Battery completely before the very first time it is used.
• Do not charge the SS-1 Smart Battery whilst fitted to your umbrella. (Always use the AC powered charger indoors
and in a dry, safe environment – charge at room temperature).
• Do not puncture the SS-1 Smart Battery as it contains a Lithium Ion Battery. Do not store your SS-1 Smart Battery
on your umbrella when not in use.
• Your SS-1 Smart Battery should not be stored for long time periods when fully charged or uncharged. Optimum
long-term storage condition is between 40%-50% charged.
• Do not expose the SS-1 Smart Battery to temperatures higher than +55°C.
• Do not dispose of the SS-1 Smart Battery via normal trash disposal. Please recycle responsibly.
This product is subject to Equipotential Bonding compliance in accordance with the
Australian/New Zealand Standards (AS/NZS 3000: 2018 Electrical Installations)
otherwise known as the Wiring Rules and the USA code, NFPA 70, National Electrical
Code (NEC) – 2020 edition - Article 680. If this product is installed within arms reach
(NZ/AU*) or 5' (USA*) of a body of water including spa, swim spa or pool, then
Equipotential Bonding MUST be performed by a licensed electrical person prior to the
product being used. This is a mandatory requirement. As the purchaser of this product,
you are responsible for ensuring compliance with this requirement at your own expense.
* Please verify the minimum distance required as stipulated by your specific regional regulations outside NZ/AU/USA
19
Figure 22.
www.shadowspec.com