Charger Information - eXact PipeCut 170 Operating Instructions Manual

Charger – Information
Operating, safety, and servicing instructions
WARNING:
DO NOT attempt to operate the tool until you have read and understood all instructions and safety rules
contained in this manual. Failure to comply may result in accidents involving fire, electric shock, or serious
personal injury. Save this owner's manual for future reference and review it frequently for safe operation.
Technical data
Model
Voltage input (AC)
Voltage output (DC)
Current
Power
Protection class
Description of the symbols:
V = Volts
A = Amperes
Hz = Herz
= Read operators manual before use
= Use only designated fuse as a replacement
Guidelines for using extension cords:
WARNING! If you are using an extension cord outdoors, be sure it is acceptable for outdoor use.
Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Battery Care
WARNING! When batteries are not in tool or charger, keep them away from metal objects.
For example, to protect terminals from shorting
DO NOT place batteries in a tool box or pocket with nails, screws, keys, etc. Fire or injury may result.
DO NOT PUT BATTERIES INTO FIRE OR EXPOSE TO HIGH HEAT. They may explode.
Battery Disposal
WARNING! Do not attempt to disassemble the battery or remove any component projecting
from the battery terminals.
Fire or injury may result. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent
shorting.
NOTE: Before disposing of damaged, check with your state Environmental Protection Agency to
find out about special restrictions on the disposal of tool or return them to a certified service center
for recycling.
DC1804
100 - 240 V / 50-60 Hz
18 V
4,0 A
95 W
/ II
~ = AC = Alternating Current
= DC = Direct Current
= Class II Construction
= Indoor use only
10
eng lish