Merax MS283457AAA User Manual page 43

REGULAR MAINTENANCE OF THE TREADMILL
STORAGE: Keep your equipment in an enclosed place, away from dust or humidity. Don't
store it neither in a garage or in indoor backyard or near water. Humidity, dust and water may
damage the equipment and have a bad effect on its function.
ELECTRIC CABLE: Make sure that the cable and plug are in perfect conditions. Electric cables
must be away from hot surfaces.
SCREWS AND CONNECTING CABLES: Supervise and tighten the screws on a regular basis,
because due to the vibration the screws and nuts tend to loosen.
LUBRICATION: It is very important to properly lubricate the treadmill with
silicone oil or Teflon. Even before the first use, it must be regularly lubricated
according to its use.
a) There is a hole for adding oil on motor cover.
b) After starting machine, please change to highest speed, then add the oil into
the hole, the oil will be spread from the middle between the running belt
and board.
c) After running for a period of time, the treadmill must be configured with the
silicone oil for lubrication.
Suggestion:
ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
< 3 hours/week
4 – 7 hours/week
> 8 hours/week
ALIGN THE BELT: Due to its use, the belt could be off-center. If the belt
has moved to the left, start the treadmill and increase the speed to 3
km/h. Use the 5mm Wrench to turn the fixed left bolt clockwise or
turn the fixed right bolt counterclockwise. In order to be able to walk,
don't fasten the running belt too tight. Repeat this procedure until the
belt is properly aligned.
If deviate to the left, then
adjust the screw on the left side
clockwise or the screw on the right
side anticlockwise.
2 months
1 month
15 days
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the right, then
43