Merax MS283457AAA User Manual page 34

Table of Contents

Advertisement

Available languages

Available languages

annulling its guarantee.
5-Place the unit on a flat surface. If the surface is uneven, the proper functioning could be affected. Some
models include levelers or levelling threads behind the legs, helping the levelling. Please read the manual to
verify if your unit is provided with one of them.
6-The unit must be placed in a ventilated area. Don't use it in places with sprays or with oxygen dispenser.
The air you breath may be affected and cause an accident.
7-Keep children younger than 12 years old and pets away from the equipment. Keep the security distance.
8-Check in the manual the maximum weight your equipment can support. An excessive weight could lead
to a malfunction in the operating system, which won't be covered by the guarantee.
9-Wear suitable clothes and shoes. Do not use loose clothe that may get hooked.
10-If your equipment is working through a power supply: make sure that the power cord and plug are in good
conditions. Carry out the connection only when the circuit has ground connection, otherwise it could cause
damages on the equipment or in the property which the guarantee won't cover. Power cords must be away
from hot surfaces.
11-If it is a battery-powered unit: check and make sure that they are charged enough so the display will fully
function.
12-If your equipment is provided with a security key, please understand the product before using it. The
security key has a magnet which must be put in the display. At the end of the lace there is a clamp which
should be attached to the clothes. The treadmill will start working ONLY if the key is placed in the display.
THIS IS ESSENTIAL.
13-If your unit works on power: do not stand on the treadmill belt before the equipment is running, as this
will unnecessarily load the motor. The correct method is to stand on the Side Rail before the treadmill runs,
and then exercise normally on the running belt after the treadmill starts to run.
14-If your unit works with an electric supply: check the speed it can reach, for your security. The best is to
adjust gradually the speed in order to avoid sudden changes.
15-If your unit works through an electric supply: never leave the machine unattended while it's working.
Take the security key off, turn the "on" button into "off" and unplug the power cord.
16-If your equipment is provided with a pulse sensor, you may know it isn't a medical instrument. It's
designed as a help for the workout and determines the tendencies of heart rates. There are some factors
which could affect the accuracy of the heart rate interpretations, for example the movements of the user.
17-The machines don't take too much space as they can be folded. Once folded, make sure that all is well
assembled to the locking system, either if it has a lock or a hydraulic engine. Don't try to move it or raise
unless you are insured. Should any damage happen being the machine uninsured, it won't be covered by the
guarantee.
18-Check and tighten all screws on a regular basis, because due to vibrations screws and nuts tend to
loosen. Damages caused by a lack of maintenance won't be covered by the guarantee.
19-A correct lubrication of the treadmill with silicon oil or Teflon is REALLY IMPORTANT. This lubrication
must be performed regularly depending on each person, even before its first use. The lubrication must be
carried out this way: disconnect the equipment of the electricity supply (in case you have one), pull up the
tapestry from the side with one hand and spread the oil on the board. Please repeat this procedure from the
other lateral side. Connect the equipment to the power supply (in case you have one) and turn the "on"
button (red button) into the correct position (I), insert the security key and let the treadmill work for several
minutes without any weight on it. Repeat this action on a regular basis.
20-Two people will be needed in order to take the unit from the package. Otherwise, the damages caused
34

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MS283457AAA and is the answer not in the manual?

Table of Contents