Grandstream Networks HT813 Administration Manual page 40

Play
busy/reord
er tone
Allow user to configure if it will play busy/reorder tone before loop current disconnect upon call fail. Default
before
is No.
Loop
Current
Disconnect
Loop
Current Configures the duration of voltage drop described in topic above. HT813 supports a duration range from
Disconnect 100 to 10000 ms. Default value is 200.
Duration
Enable
Pulse Allow users to enable Pulse Dialing option under FXS Port. Default is No.
Dialing
Pulse
This feature allows users to use Swedish pulse dialing standard or New Zealand pulse dialing standard.
Dialing
Default is General Standard.
Standard
Enable
Enables the FLASH button to be used for terminating calls. Default is Yes.
Hook Flash
Defines the time period when the cradle is pressed (Hook Flash) to simulate FLASH. To prevent unwanted
activation of the Flash/Hold and automatic phone ring-back, adjust this time value. HT813 supports a range
Hook Flash
from 40 to 2000 ms.
Timing
Default values are 300 minimum and 1100 maximum.
On Hook Specifies the on-hook time for an on-hook event to be validated. HT813 supports a range from 40 to 2000
Timing ms. Default value is 400.
Adjusts the voice path volume.
• Rx is a gain level for signals transmitted by FXS
• Tx is a gain level for signals received by FXS.
Default = 0dB for both parameters. Loudest volume: +6dB Lowest volume: -6dB.
Gain
User can adjust volume of call using the Rx gain level parameter and the Tx gain level parameter located on
the FXS port configuration page. If call volume is too low when using the FXS port (i.e. the ATA is at user
site), adjust volume using the Rx gain level parameter under the FXS port configuration page. If voice volume
is too low at the other end, user may increase the far end volume using the Tx gain level parameter under
the FXS port configuration page.
Disable
Disables the LEC will per call base. Recommended for FAX/Data calls.
Line Echo
Canceller
Default is No.
(LEC)
Disable
Disables the NEC will per call base. Recommended for FAX/Data calls.
Network
Echo
Default is No.
Suppressor