Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Grandstream Networks HT8 Series
Summary of Contents for Grandstream Networks HT8 Series
- Page 1 Grandstream Networks, Inc. Peering HT8XX with HT813...
-
Page 2: Table Of Contents
Table of content OVERVIEW ........................2 PEERING HT8XX WITH HT813 ..................3 HT8XX Configuration ..........................3 HT813 Configuration ..........................5 Table of figures Figure 1: Peering HT8xx with HT813 ......................3 Figure 2: FXS Port settings ........................... 4 Figure 3: FXO Port settings........................... 6 Figure 4: FXO Port settings........................... -
Page 3: Overview
OVERVIEW This document describes basic configuration to peer HT8XX series with HT813. This configuration applies to users seeking to add a HT813 not only as a remote extension but also as an external PSTN trunk. The document will demonstrate a scenario where you can set up HT8XX series with the HT813. P a g e Peering HT813 with HT8XX... -
Page 4: Peering Ht8Xx With Ht813
PEERING HT8XX WITH HT813 A common scenario which involves one HT8XX (ATA) and HT813 but doesn’t involve any SIP server. This scenario allows organization with remote location to access FXO trunks through IP network. In this scenario, we will proceed first from the web GUI of HT8XX, then on the HT813 in order to configure the Peer Trunk on both sides Figure 1: Peering HT8xx with HT813 Note: HT8XX can include HT801/802/814/812/818... -
Page 5: Figure 2: Fxs Port Settings
Figure 2: FXS Port settings Notes: • SIP User ID and Authenticate ID should be the same. • Always set Random Ports to “No”. P a g e Peering HT813 with HT8XX... -
Page 6: Ht813 Configuration
HT813 Configuration On the HT813 web GUI, access to “FXO Port”, then set the following: • Primary SIP Server: Set to <IP_address_of_HT-802>, which is in our case: 192.168.5.159. • SIP User ID: Any Number, in our case it will be 6666. •... -
Page 7: Figure 3: Fxo Port Settings
Figure 3: FXO Port settings P a g e Peering HT813 with HT8XX... -
Page 8: Figure 4: Fxo Port Settings
Figure 4: FXO Port settings Notes: • SIP User ID and Authenticate ID Should be the same • Stage Method 2 doesn’t apply for peer to peer. It works when registered with a SIP Server. • Always set Random Ports to “No”. On the HT813 web GUI, access to “Basic Settings”, then set the following: •... -
Page 9: Figure 5: Basic Settings Configuration
Figure 5: Basic settings configuration Note: In order for this setup to work, it is extremely important that both Handy Tones (HT813 and HT8xx) are located on the same LAN OR have Public Static IPs. In short, the Handy Tones should be able to locate each other.