Grandstream Networks HT813 Administration Manual page 15

SSH 2. Yes: Access for the Web GUI and SSH is enabled on the WAN side.
Acce 3. Auto:Only private IP could access the web or SSH on the WAN side.
ss
Default setting is Auto.
Whit
If WAN Side Web/SSH Access is set to Yes or Auto. Users can configure the white List for WAN Side to be used for
e
remote management.
List
Multiple IPs are supported and need to be separated by space.
for
Example:192.168.5.222 192.168.5.223 192.168.7.0/24
WAN
Note: If both blacklist and whitelist are not empty, the blacklist is processed first, followed by the whitelist.
Side
Blac
If WAN Side Web/SSH Access is set to Yes or Auto. Users can configure the black List for WAN Side to ban WAN side
k
web access.
List
Multiple IPs are supported and need to be separated by space.
for
Example:192.168.5.222 192.168.5.223 192.168.7.0/24
WAN
Note: If both blacklist and whitelist are not empty, the blacklist is processed first, followed by the whitelist.
Side
Selects one of the following IP protocol modes:
Inter
1. IPv4 Only:Enforce IPv4 protocol only.
net
2. IPv6 Only:Enforce IPv6 protocol only.
Prot
3. Both, Prefer IPv4:Enable both IPv4 and IPv6 and prefer IPv4.
ocol
4. Both, prefer IPv6:Enable both IPv4 and IPv6 and prefer IPv6.
Note: Make sure to reboot the ATA for the changes to take effect.
IPv4
Allows users to configure the appropriate network settings on the HT813 to obtain IPv4 address. Users could select
Addr
DHCP, Static IP or PPPoE. By default, it is set to DHCP.
ess
Dyna All the field values for the static IP mode are not used (even though they are still saved in the flash memory.) The
mica ATA acquires its IP address from the first DHCP server it discovers from the LAN it is connected.
lly DHCP hostname:Specifies the name of the client. The name may or may not be qualified with the local domain name.
assig This field is optional but may be required by ISP.
ned DHCP domain name: allows user to configure DHCP domain name. This option specifies the domain name that the
via client should use when resolving hostnames via the Domain Name System. This field is optional.
DHC DHCP vendor class ID: Exchanges vendor class ID by clients and servers to convey particular configuration or other
P identification information about a client. Default isHT8XX.
Set the PPPoE account settings. If selected, ATA attempt to establish a PPPoE session if any of the PPPoE fields is
set.
Use PPPoE account ID:Defines the PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point
PPP Protocol over Ethernet) connection.
oE PPPoE password:Specifies the PPPoE account password.
PPPoE Service Name:Defines PPPoE service name. If your ISP uses a service name for the PPPoE connection, enter
the service name here. This field is optional. Default is blank.
Pref
erred
Specifies preferred DNS server to use when DHCP or PPPoE are set.
DNS
You can set up yo 4 Preferred DNS Servers.
serv
er
Stati
cally
confi
Configure IP address, subnet Mask, default router IP address, 1st preferred DNS server, 2nd preferred DNS server.
gure
d as These fields are set to zero by default.
IP
addr
ess