Grandstream Networks HT813 Administration Manual page 17

widt configured, there will be at least 512kbps limited for internal system, signaling and NATed traffic. Voice or RTP
h stream will never be limited.
Dow Specifies the maximum downlink bandwidth permitted by the device. This function is disabled by default. The total
nlink bandwidth can be set as: 128K, 256K, 512K, 1M, 2M, 3M, 4M, 5M, 10M or 15M. The primary function of this setting
Band is to limit the download bandwidth for the device internal system, signaling and NATed traffic. Example: if 128 is
widt configured, there will be at least 128kbps limited for internal system, signaling and NATed traffic. Voice or RTP
h stream will never be limited.
Enab
le
UPn When set to Yes, the HT813 acts as a UPnP gateway for your UPnP-enabled applications.UPnP = Universal Plug and
P Play. The default is No.
Supp
ort
Repl
y to
ICM When set to Yes, the HT813 responds to the PING command from other computers but is also made vulnerable to
P on DOS attacks. The default is No.
WAN
Port
Clon
ed
WAN
This allows the user to change/set a specific MAC address on the WAN interface. Note: Set in Hex format.
MAC
Addr
ess
Enab
When set to Yes, the device will function as a simple router and the LAN port will provide IP addresses to the internal
le
LAN network. Connect the WAN port to ADSL/Cable modem or any other equipment that provides access to the public
Internet
DHC
P
LAN Base IP Address for a LAN port. The default factory setting is 192.168.2.1. Note: When the device detects WAN IP is
DHC conflicting with LAN IP, the LAN base IP address will be changed based on the network mask the effective subnet
P will be increased by 1.
Base For example; 192.168.2.1 will be changed to 192.168.3.1 if the net mask is 255.255.255.0. Then the device will
IP reboot
LAN
DHC
The default value is 100. The last segment of IP address is assigned to the HT813 in the LAN Network.
P
Default configuration assigns IP address (to local network devices) starting from 192.168.2.100.
Start
IP
LAN
DHC
Default value is 199. This parameter allows a user to limit the number of local network devices connected to the
P
internal router.
End
IP
LAN
Subn
Sets the LAN subnet mask.
et
Default value is 255.255.255.0
Mas
k
DHC Default value is 120 hrs. (5 days). The length of time the IP address is assigned to the LAN clients. Value is set in
P IP units of hours.