Table of Contents
Advertisement
Scanner
end
Check your local manual handling guidelines before lifting, as the unit weighs approximately 60Kg.
Remove the middle section of the case.
There are three locating areas machined
into the legs that match the width of the leg
clamps. The Lidar will be delivered with the
clamps set to the lowest position, and it is
recommended that it be left at this position.
The small pillars with rubber-coned ends
act as support legs when the 4 main legs
are not attached. They prevent the weight
of the Lidar being taken by the cooling
aggregate mounted on the underside of
the main base plate, which would cause
damage.
The feet should all be roughly in the centre
of their positioning recess when the Lidar is
located correctly. Note that the unit will fit
properly in one orientation only.
Lift the unit clear of the transit case tray.
The UPS unit can now also be removed –
along with any other additional parts that
were packed.
Packing the system back up is relatively
straightforward, and is a reverse of the
unpacking procedure. Ensure correct
orientation as shown below.
Connector
panel end
Advertisement
Table of Contents
