Table of Contents
Advertisement
9.2.4 Additional displays.
After the schedule has been changed and the schedule 'Finished' button has been pressed, the schedule software
will need to be closed. The Reload schedule button will then need to be pressed before the amended schedule is
used.
The currently loaded schedule is displayed along with the scan pattern that is currently being performed along with
their repeat time in seconds and the number of seconds until the next repeat.
[Back to contents]
The 'C/C' button next to any currently displayed scan can be pressed
to continuously cycle the chosen scan. If multiple C/C buttons are
pressed, those scans will repeat, one after the other. During this
mode, the 'Reload schedule' button will not be available. To edit the
schedule, you must use the icon located on the desktop, and reload it
once finished.
If some scans are set to continuously cycle, any other scans not set
to cycle will run at their selected repeat interval. The Wind profile
scan does not have a C/C option.
Advertisement
Table of Contents
