Table of Contents
Advertisement
8.1 Remote connection software.
After the Lidar PC has been given time to boot up, run the client remote PC software on the connected PC. The
following screen will be displayed:
If the connection is made via a crossover cable connected directly to RJ45-X on the Lidar, then the following Remote
computer name is used: 192.168.0.1
If a LAN is being used, then the IP address that has been assigned to the Lidar by the router will need to be entered
instead. It's also possible that the Lidar will be listed in the drop down menu – if it is, you should be able to use that
instead of having to enter an IP address.
If the PC name isn't listed, the address that is assigned to the Lidar by your dynamic DNS system must be used. To
find this, it will be necessary to connect to the Lidar using method 1 or 2 as above, so that the IP assigned to the
relevant LAN connection can be observed. This IP address can then be used to connect to the system.
Once the appropriate IP address has been entered as shown above and the connect button clicked, the username
and password dialogue box will appear.
[Back to contents]
Enter the system serial number for the user name, and the same
reversed for the password. For example, 0102-03 for the username, and
30-2010 for the password including the - character.
Click the 'Remember password' check box, so that the username and
password doesn't have to be entered each time a connection is made, then
click OK to connect.
Use 192.168.0.1 if connected
using a crossover cable into
RJ45-X.
If you are connecting over a
LAN, you will need to enter the
IP address that has been
assigned to the system.
You may also see the computer
name if you select the drop
down menu. If you can see it,
you can select it instead of
entering an IP address.
Advertisement
Table of Contents
