Table of Contents
Advertisement
9.2.7 Stopping the Software.
Press the
The software will stop, and a message will be displayed stating that the power should be left on for a few minutes to
allow the internal fans to remove residual hot air from the internal electronics.
After 5 minutes or so, the Shutdown software can be run.
10 Shutting down.
[Back to contents]
Double click the Shutdown icon to load up the software.
Description:
This module will shut down the internal systems of the Lidar in a controlled manor, and will also shut down the PC if
the option is selected.
When to use:
Use whenever the system is going to be powered off or not used for data collection i.e. for data transfer.
Press the run button
[Back to contents]
button on the Real time data tab to stop the software and park the scanner.
to start the chosen shutdown procedure.
Both switch options are shown here.
the required option prior to running the
software.
The option to abort the PC switch off
will be displayed for 10 seconds.
Choose
Advertisement
Table of Contents
