Table of Contents
Advertisement
7. Site considerations.
It is highly recommended that the Lidar be deployed on a surface that is not liable to get excessively hot, as the
cooling aggregate (air-flowed heat exchanger) is located on the underside of the base unit. Steps should be taken to
minimise the heat generated underneath the Lidar from direct sunlight - a turfed area is ideal.
Ambient temperatures quoted in the temperature specification of the Lidar are with respect to the air entering the
cooling unit, and not the general ambient temperature on site as measured by a sensor inside a solar shield.
[Back to contents]
The power supply module should be located directly underneath
the Lidar, and raised off the ground if possible to reduce
exposure to the weather and sunlight.
Advertisement
Table of Contents
