Calibrating Print Bed - Renkforce 3D Drucker Cube One Operating Instructions Manual

9.7 Calibrating print bed

By calibrating the print bed you make sure the print bed is level. The mobile app will guide you through four calibration
points that you must check with the help of the supplied levelling paper. You might need to adjust the distance between
print bed and extruder by turning the hex screws at the calibration points.
The print bed must be calibrated before using the printer for the first time. For consecutive prints, it is not necessary
to calibrate the print bed before every print.
Notes:
While you adjust the hex screw at a given calibration point, it might be necessary to re-adjust some of the hex
screws of other calibration points.
Preconditions:
Printer is switched on.
D
1. Slide the levelling paper between the extruder and the print bed.
2. In the mobile app go to Printer > Levelling.
3. Touch Start levelling to start the print bed calibration process.
The extruder moves to the first calibration point. See Fig. F-2.
Æ
4. Slide the levelling paper between the print bed and the extruder. If the paper
can be moved rather easily between the nozzle and the extruder, turn the
hex screw anticlockwise while moving the paper until you notice slight resist-
ance. If the paper sits very tight, turn the screw clockwise instead.
You have calibrated the first calibration point.
Æ
5. In the mobile app, touch Next to calibrate the second calibration point.
6. Continue calibrating the remaining calibration points.
13 : 44
Printer
Online PrinterXXXX
Status Serial Number Model
Pre-heat Home Levelling
4 3
1 2
Next
Model Printer Video
F-2
Add printer
Temperature
Manual
Me
31