F) First Print Of An Example Object From The Sd Card - Renkforce RF1000 Manual

Push the direction button „left" 2x to return to the main menu.
Wait until the actual temperature of the heating plate in the
display shows room temperature again.
f) First Print of an Example Object from the SD Card
When heating, there may be slight development of smoke or steam. This is normal. Please ensure the corresponding
ventilation.
If you are printing with PLA filament, cover the heating plate with cleaning tape or a slightly structured crepe tape.
You can find the print files on the enclosed SD card in the folder GCODE. The printing files are saved in the two folders
"ABS" and "PLA" depending on the filament type used.
Push the enclosed SD card into the SD card reader at the right of the 3D printer.
Push OK and select „SD-Card" with the direction buttons. If
the printer was already switched on before insertion of the SD
card, the option „Mount Card" must be performed.
Push OK and mark the desired file in the corresponding folder
„ABS" or „PLA" with the direction buttons.
The progress of heating of the heating plate and extruder can be tracked based on the temperature displays in the upper
display line.
The printing progress can be tracked in the lower status display.
Push OK and select „Print file" with the direction buttons.
Confirm with OK.
The display returns to the main menu and the heating plate is
heated.
Then the axes move to the home position and the extruder is
heated.
Once the extruder has reached its operating temperature,
printing starts.
3