Linking Printer To Mobile App And Wi-Fi - Renkforce 3D Drucker Cube One Operating Instructions Manual

9.6 Linking printer to mobile app and Wi-Fi

To control the printer via the mobile app, you must link it to the app through a Wi-Fi network (2.4 GHz). You will use
the mobile app to connect the printer to the Wi-Fi network.
You can link a printer to more than one mobile app but control the printer from only one mobile app at any given time.
You can also link multiple printers to the same mobile app.
Note:
The printer and the mobile device that runs the app must connect to the same Wi-Fi network. Network separa-
tions (example: subnet, VLAN) are not supported.
1. Press the power button to switch the printer on.
2. Open the mobile app.
3. Open the window Printer.
4. In the window Printer, touch Add Printer.
5. Follow the instructions to connect the printer to the Wi-Fi network.
The printer is added to the window Printer (Fig. F-1).
Æ
The printer is linked to the mobile app.
Æ
The printer is connected to the Wi-Fi network. The printer will re-connect to
Æ
the Wi-Fi network the next time it is switched on.
Note:
If the printer does show in the mobile app after switching on, follow the in-
structions in [ ►12.2 Troubleshooting Wi-Fi connections
30
].
13 : 44
Add printer
Online PrinterXXXX
Status Serial Number Model Temperature
Pre-heat Home Levelling
90℃
PCL Pre-heat
190℃
PLA Pre-heat
STOP
Loading Stop Unloading
Print
Model Printer Video
F-1
Manual
Stop
Heating
Me