HP 8340B Manual page 177

Performing
the Modification
After
you
determine the modifications required to the
HP-IB address assignments, perform the follow¬
ing:
1.
Boot up HP Basic
with
the appropriate binary extensions needed for your system.
If
using an
HP9133H, 9153A, or 9122D, the binary extensions listed
under
OPERATING SYSTEM
in
section
2
are
all
you need.
2.
LOAD-JANITOR".
3.
EDIT
Asgn_test_equip.
4
To change the HP-IB address of
a
piece of test equipment, scroll to the line
that ASSIGNS the
address to
the instrument you wish to modify.
Make the address
change
and
ENTER
the
line.
Example:
To change the device under test's HP-IB address assignment to
30, scroll to the
"ASSIGN @Dut TO 719"
line and
change 719
to
730. After making the change, press
ENTER
on
your computer's keyboard.
5.
Check the HP-IB assignments
to ensure
that
the modifications you
made
are correct. Also check
that there are no duplicate addresses.
6.
If
the
storage media
you are
using for the test software is
a floppy,
PURGE "JANITOR".
7-
RE-STORE "JANITOR".
3-6
How
to Configure the Software
Attenuator Calibration and Operation Verification Test Software