HP 8340B Manual page 174

1362
1363
1364
1386
1387
1388
1389
1390
1391
1392
1393
1408
1409
1410
1411
1412
1413
1414
SUBMaaa-atg-inIt
Maaa-atg-init:
!
Managerays$
Dut-mau5$
Manageraya<-"
"
Maus$-":,700,0"
!
Dut-dir$-""
Dut-maus(-":,700,1"
i
Dut-dir$
Directory pointer for Teat
System program
file
a
and CalFactor
filea.
Maaa
storage
unit apecifer for Teat
system
program
files.
Menu filea,
and Cal
Factor
files.
Directory pointer for
DUT
data fllea.
Maaa
storage
specifier for
DUT
datafllea.
Figure 3-1. Subprogram
Mass_stg_init,
Partial Listing
Performing the Modification
After you determine the modifications required to the system variables, perform the following.
1.
Boot
up
HP Basic
with the appropriate binary extensions needed for your system.
If
using an
HP 9133H, 9153A, or 9122D, the binary extensions
listed
under
OPERATING SYSTEM
in
section
2
are
all
you need.
2.
Insert the test
software's disc
1,
and LOAD
"FS_MANAGER".
3.
EDIT
Mass_stg_init.
4.
Scroll to the
system variables to be modified and make the appropriate changes. ENTER each
line
after modifying.
5.
Check the system variables to ensure
that the modifications you
made are correct.
6.
If
the storage media you are using for the test software
is
a
floppy,
PURGE
"FS_MANAGER".
7.
RE-STORE
"FS_MANAGER".
Attenuator Calibration and Operation
Verification Test Software
How to Configure the Software