Appendix 5 - Installation Of Ac Junction Box - NewMar Centurion II Power System Installation & Operation Manual

Dc power system -48 vdc and +24 vdc

Hide thumbs Also See for Centurion II Power System:

Table of Contents

5 –

PPENDIX

Cable Tie

Mount

Supplied Cable Clamps

2 x 3/8" NM Cable Clamp

1 x 3/4" NM Cable Clamp

1. The above illustration shows the rear and side of the AC junction box.

2. To remove the junction box cover, loosen the four screws located at the top of the AC junction box.

3. Loosen cable clamp screws and route AC cables though cable clamps. Connect AC

cables to AC input terminal block. (See Centurion II Input wiring options (M-C2ACOPT)

drawings for wiring options)

4. Tighten cable clamp screws and confirm the cables are firmly secured.

5. Re-install top cover and tighten screws.

INSTALLATION OF AC Junction Box

Newmar • PO Box 1306, Newport Beach, CA 92663

• Phone: 714-751-0488 • E-mail: techservice@newmarpower.com

Loosen Screws to Remove Cover x 4

AC Junction Box

(Right Rear)

Centurion II

Rectifier Shelf

Table of Contents

C2rs