TABLE OF CONTENTS
Section Description
1
Receiving Instructions ............................................................................................................. 2
2
Scope ....................................................................................................................................... 2
3
System Overview .................................................................................................................... 3
4
Installation ................................................................................................................................ 3
4.1
4.2 AC Cabling .............................................................................................................................. 4
4.2.1
4.3 DC Cabling.............................................................................................................................. 6
4.3.2
4.4
Alarm/Ancillary Cabling .......................................................................................................... 8
5
LVD Operation ...................................................................................................................... 10
6
Commissioning ...................................................................................................................... 11
7
8
Appendix 2 - Maintenance .................................................................................................. 20
9
10
11
12
13
14
Installation CD
You may have received a CD with your Centurion II Power System. This contains the user manuals relevant to the
System you have purchased, plus the SM3x Configuration Software. This software enables direct communication
from your computer to the SM3x via the USB port.
Note: You will require Administrator rights on your computer to install this software.
If this is the first time you have used the SM3x Configuration Software, then the installation process will guide you
through the installation of:
the USB drivers,
the Microsoft .Net Framework
the SM3x Configuration Software itself
Upon inserting the CD, open the file directory. In the root directory there is a file called Setup_sm3xconf_4.2.exe.
Double click on this and you will be guided through the installation process. Normally, you should only be required to
click "next" on all prompts.
The number "...4.2" denotes the release issue of the Configuration Software (the file you receive may be 4.3, 4.4 or
greater). If you have an earlier version installed than the number denoted there, then you can automatically update
your existing software by double-clicking on this .exe file (it will not re-install your USB drivers or the .Net
Framework).
The first time you connect your computer to a SM3x via the USB, Windows will "find new hardware". Proceed to
install the drivers "automatically". If, during this process, you get a message from Windows stating that the driver is
unsigned, it is not a problem. You must continue with the driver installation.
Newmar • PO Box 1306, Newport Beach, CA 92663
• Phone: 714-751-0488 • E-mail: techservice@newmarpower.com
1
Page