Human Exposure Compliance Statement; Compliance With Fcc Regulations - Enfora Enabler II-G Integration Manual

Integration Guide
Version 1.01

Human Exposure Compliance Statement

GSM0108 Quad-Band Module
Enfora certifies that the Enfora Enabler II-G 850/900/1800/1900 MHz GSM Radio Module (FCC ID:
MIVGSM0108) complies with the RF hazard requirements applicable to broadband PCS equipment
operating under the authority of 47 CFR Part 24 (and Part 22 for GSM 850), Subpart E of the FCC Rules
and Regulations. This certification is contingent upon installation, operation and use of the Enfora Enabler
II-G and its host product in accordance with all instructions provided to both the OEM and end used. When
installed and operated in a manner consistent with the instructions provided, the Enfora Enabler II-G meets
the maximum permissible exposure (MPE) limits for general population / uncontrolled exposure at defined in
Section 1.1310 of the FCC Rules and Regulations.
Note: Installation and operation of this equipment must comply with all applicable FCC Rules and
Regulations, including those that implement the National Environmental Policy Act of 1969 (Part 1, Subpart
I), with specific regard to antenna sitting and human exposure to radio frequency radiation. For further
guidance, consult the FCC Rules, your service provider, or Enfora.

Compliance with FCC Regulations

The Federal Communications Commission (FCC) is the agency of the Federal Government that oversees all
non-governmental radio frequency transmitters that operate within the United States. Unintentional
emissions from digital devices are regulated by Part 15 of the FCC Rules and Regulations, which
distinguishes between the environments in which these devices may operate. Intentional radiators operating
as a PCS-1900 radio transmitter are regulated under Part 24, Subpart E—Broadband PCS of the FCC Rules
and Regulations.
GSM0108PB001 Page 61 1.01 – 01/21/05