Enfora Enabler II-G Integration Manual page 55

Integration Guide
Version 1.01
10.1.3 Initial Response to the AT Command
After power is applied to the Enfora Enabler II-G module, the module performs a power-up self-test. The
self-test completes within one (1) second. When queried with the AT command, the Enfora Enabler II-G
module responds with one of the following result codes:
•
OK signifies that the Enfora Enabler II-G module is ready, that it correctly interprets the AT command,
and that it has executed the command.
•
ERROR signifies that the Enfora Enabler II-G module does not understand the command or that the
command is invalid.
Entry
Response
The Enfora Enabler II-G module must be in AT Command mode (please refer to section 10.3 GPRS Packet
Examples for packet mode initialization and setup) when any command is entered (with the exception of the
online escape sequence). Commands entered when the module is in On-line mode are treated as data, and
are transmitted as such to the receiving module. i.e. If the module is in PPP or SLIP mode, AT commands
cannot be entered.
10.1.4 Sending an Initialization String to the Enfora Enabler II-G Module
The following example provides the sample AT commands and responses for the following initialization
tasks:
•
Reset the module to the factory defaults
•
Disable character echo
•
Transmit Result Codes
•
Set the module to Verbose mode (to display result codes as words)
•
Set the DCD to match the state of remote modem
• Ignore the DTR
Entry AT&FE0Q0V1&C1&d0
Response
OK
Entry ATSO=1
Response OK
10.1.5 Setting Up the Communication Mode for the Enfora Enabler II-G Module
The following example sequence provides the AT command and response for setting the Enfora Enabler II-
G module for full phone functionality, automated operator selection, 9600 baud, non-transparent mode.
Entry
AT+CFUN=1
Response OK
Entry
AT+COPS=0
Response
OK
Entry AT+CBST=7,0,1
Response OK
GSM0108PB001
AT
OK Command valid: module is ready
Initialization string
Command is valid
Auto answer on 1st ring
Command is valid
FULL phone functionality
Command is valid
Automatic operator selection
Command is valid
9600 baud, non-transparent mode
Command is valid
Page 54 1.01 – 01/21/05