Setup And Initialization; General Setup; Figure 26 Hyperterminal Definition - Enfora Enabler II-G Integration Manual

Integration Guide
Version 1.01

10.0 Setup and Initialization

10.1

General Setup

The GPRS modem is controlled through the Modem RS232 port on the development board. Connect a nine
pin straight through serial cable from the Modem RS232 connector to the serial port on the controlling
computer.
Hook up power supply, connect antenna, and install SIM into modem.
10.1.1 HyperTerminal Configuration for Enabler II-G
The following provides an example for setting up a Windows HyperTerminal session that can be used to
experiment with various configurations on the Enabler II-G for controlling computer:
1. Select the connection interface, Direct to Com 1 (or whatever port is the serial port).
Figure 25 HyperTerminal Definition
GSM0108PB001 Page 52 1.01 – 01/21/05