How To Restrict Wireless Access By Mac Address - NETGEAR WAG102 Reference Manual

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
Once your PCs have basic wireless connectivity to the WAG102, you can configure the advanced
wireless security functions.

How to Restrict Wireless Access by MAC Address

To restrict access based on MAC addresses, follow these steps:
1. Log in to the WAG102 using its default address of
address the unit is currently configured. Use the default user name of admin and default
password of password, or whatever LAN address and password you have set up.
Note: When configuring the WAG102 from a wireless computer whose MAC address
is not in the access control list, if you select Turn Access Control On, you will
lose your wireless connection when you click Apply. You must then access the
wireless access point from a wired computer or from a wireless computer
which is on the access control list to make any further changes.
2. From the Security menu, click the Access Control 11a and 11bg links to display the Access
Control menus shown below.
Access Control 11a menu
Figure 3-11
3-24
http://192.168.0.232
Access Control 11b/g menu
v1.0, September 2005
or at whatever IP
Basic Installation and Configuration