NETGEAR WAG102 Reference Manual page 31

Prosafe dual band wireless access point
Hide thumbs Also See for WAG102:
Table of Contents

Advertisement

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
You may enable the DHCP client to let the Access Point getting its TCP/IP
configuration from the DHCP server on your network.
DHCP Client: The access point will get the IP address, subnet mask and the default
gateway settings automatically from the DHCP server if DHCP is enabled.
IP Address: Type the IP address of your Access Point (factory default:
192.168.0.232).
IP Subnet Mask: The Access Point will automatically calculate the subnet mask
based on the IP address that you assign. Otherwise, you can use 255.255.255.0 as the
subnet mask.
Default Gateway Address: The Access Point will use this IP address default gateway
for any traffic beyond the local network.
DNS Server: The Access Point will use this IP address as the Domain Name Server
used by stations on your LAN.
Time Zone: You may select the appropriate local time zone for your Access Point
from a list of all available time zones. The default is GMT.
3. Click the Wireless Settings11a link in the Setup section of the main menu to view the Wireless
Settings 11a menu.
Figure 3-5
Basic Installation and Configuration
v1.0, September 2005
3-9

Advertisement

Table of Contents
loading

Table of Contents