Hardware Description; Front Panel - NETGEAR WAG102 Reference Manual
Prosafe dual band wireless access point
Hide thumbs
Also See for WAG102:
- Reference manual (102 pages) ,
- Installation manual (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
Hardware Description
The WAG102 front and rear hardware functions are described below.
Front Panel
Figure 2-1
The following table explains the LED indicators:
LED
DESCRIPTION
PWR
Power Indicator
Off
No power.
On
Power is on.
TEST
Self Test Indicator
Blink
Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
100 LINK/ACT
Ethernet LAN Speed Indicator
Off
Indicates no 100 Mbps Ethernet link detected
Green Solid On
100 Mbps Fast Ethernet link detected, no activity
Green Blink
Indicates data traffic on the 100 Mbps Ethernet LAN.
10 LINK/ACT
Ethernet LAN Link Activity Indicator
Off
Indicates no 10 Mbps Ethernet link detected.
Green Solid On
10 Mbps Fast Ethernet link detected, no activity.
Green Blink
Indicates data traffic on the 10 Mbps Ethernet LAN.
2-6
v1.0, September 2005
Introduction
Advertisement
Table of Contents
