NETGEAR WAG102 Reference Manual page 30

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
Figure 3-4
f. Configure the settings appropriate for your network. The default values are suitable for
most users and situations.
• Access Point Name: This unique name is the access point NetBIOS name. The
default Access Point Name is located on the bottom label of WAG102. You may
modify the default name with a unique name up to 15 characters long. The default is
netgearxxxxxx, where xxxxxxx represents the last 6 digits of the WAG102 MAC
address.
• Country/Region: This field identifies the region where the WAG102 can be used. It
may not be legal to operate the wireless features of the wireless access point in a
region other than one of those identified in this field. Select your country or region
from the drop-down list. This field displays the region of operation for which the
wireless interface is intended.
If your country or region is not listed, please check with your local government
agency or check our website for more information on which channels to use. The
802.11g wireless channel in use will be between 1 to 11 for US and Canada, 1 to 13
for Europe and Australia.
• IP Address: By default, the DHCP (Dynamic Host Configuration Protocol) client
service is disabled. The default IP address is 192.168.0.232.
3-8
v1.0, September 2005
Basic Installation and Configuration