Titan TTCSP40 Manual page 53

TTCSP40
Long term storage
NOTE: Risk of product damage!
> If you are not going to be using the product for a while, remove the fuel and
saw chain oil from the product. This way, you will prevent a gumming-up
of the engine and of the grease pump.
> Store the product in a dry place and far away from possible sources of
ignition such as ovens, gas thermostats, etc.
1. Empty both tanks if you are not going to use the product for an extended period of
time (more than 3 months) and before storing it for the winter.
2. Start the engine and let it run until the engine stops by itself (see "Starting the engine").
3. Let the engine cool down (approx. 5 min).
4. Disconnect the spark plug connector (6a) and remove the spark plug.
5. Let a teaspoon of clean two-stroke engine oil run into the combustion chamber.
6. Pull the recoil starter handle (15) slowly several times in order to coat the internal
components with the oil.
7. Refit the spark plug.
Transportation
1. Stop the engine and disconnect the spark plug connector (6a) before transporting
the product anywhere.
2. Attach transportation guards, if applicable.
3. Always carry the product by its handle.
4. Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
5. Secure the product to prevent it from slipping or falling over, loss of fuel, damage
and injury.
If you are transporting the product in a vehicle:
> Let the product cool down.
> Empty both tanks.
> Secure the product against slipping using bungee cords or other similar means.
Care and maintenance
53