Titan TTCSP40 Manual page 20

Before you start
8. Refit the clutch cover (20) and fasten using the fixing nuts (18) and the multi-tool (24).
To fit the clutch cover, align the tensioner pin with the lower hole on the guide bar (2)
by turning the chain tension adjuster (19) clockwise or anti-clockwise with the multi-
tool (24) (Fig. 6).
NOTE: Tighten the fixing nuts (18) finger tight only at this stage. The chain
tension cannot be adjusted with the fixing nuts fully tightened.
6
19
Tightening the saw chain
Always check the saw chain tension before use, after the first cuts and regularly during
use, approx. every five cuts. Upon initial operation, new chains can lengthen considerably.
This is normal during the break-in period and the interval between future adjustments
will lengthen quickly.
20
20
18
Tensioner pin
24
TTCSP40