Titan TTCSP40 Manual page 43

TTCSP40
Cleaning the saw chain
> Use a soft plastic brush to clean the saw chain (3) from dirt.
> Use a resin solvent (not provided) to clean the saw chain. Read the resin solvent
manufacturer's instructions before proceeding.
> To protect the saw chain from rust and oxidation, lubricate it with a special saw chain
oil (not provided).
Cleaning the guide bar
> Disassemble the guide bar (2) and saw chain in
reversed order from assembly.
> Remove any dirt accumulated inside the guide bar
slot using the putty knife (not provided) (Fig. 39).
> Use a damp, lint-free cloth to clean the surface.
> Wipe the surface with a dry cloth afterwards.
Maintenance table
Inspect and maintain this product regularly based on below maintenance table. Keep
the chain saw in good working condition during maintenance.
Part
Overall
Cylinder
fins
Spark plug
replace
lubricate
Saw chain
sharpen
replace
lubricate
Guide bar
replace
Task Before/after
each use
check X
clean X
clean
check
clean
check X
X
clean X
check X
clean
Care and maintenance
39
Every 10 hours
of operation
X
whenever necessary
whenever necessary
whenever necessary
X
X
whenever necessary
Every 25 hours
of operation
X
X
43