Titan TTB773HTG Manual page 26

Operation / Care and maintenance
EN EN
After use
> Turn the on/off switch to "I" position and let the product run for a few minutes
to reduce the cooling time
> Switch the product off, place it on its stand (3), disconnect it from the power
supply and let it cool down (Fig. 3).
> Check, clean and store the product as described below.
The golden rules for care
WARNING! Always switch the product off, disconnect it from the
power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
> Keep the product clean. Remove debris from it after each use and before
storage.
> Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
> Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING! Only perform repairs and maintenance work according
to these instructions! All further works must be performed by a
qualified specialist!
General cleaning
> Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
> In particular clean the air vents (2) after every use with a cloth and brush.
> Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
> Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using the
product again.
26
TTB773HTG by TITAN