Controller / Fieldbus Gateway - SEW-Eurodrive MGF-DSM Series Addendum To The Operating Instructions

3.4

Controller / fieldbus gateway

The following chapter describes application controllers or fieldbus gateways suitable
for the MGF..-DSM drive unit and MOVITRAC
3.4.1 Configurable application controller CCU
The following controllers in the "CCU standard" performance class are supported:
DH.21B / 41B de-
vice type
DHF21B
DHR21B
The controller can be used as configurable application controller (CCU) by using an
OMC41B type SD card. You can then only execute standardized application modules
created by SEW-EURODRIVE.
The application modules can be started up quickly and conveniently by graphical con-
figuration. A defined process data interface provides this functionality to a higher-level
controller.
A process data monitor with control mode is available to support the startup proce-
dure.
The "CCU standard" performance class is intended for application modules with sin-
gle-axis functionality and medium response times. A maximum of 16 axes can be con-
nected to a configurable application controller.
For further information, refer to the "Controller DHE21B / DHF21B / DHR21B (stand-
ard), DHE41B / DHF41B / DHR41B (advanced)" manual.
3.4.2 Fieldbus gateways
The following fieldbus gateways are supported for connecting the MGF..-DSM drive
unit and MOVITRAC
tem:
Bus system / Industrial Ethernet Design
PROFIBUS
DeviceNet
PROFINET
EtherNet/IP™
Modbus TCP
EtherCAT
+ SD card Bus system / Industrial Ethernet Number of
OMC41B
OMC41B
® LTP-B frequency inverter system to a fieldbus or Ethernet sys-
® slave
Controller / fieldbus gateway
® LTP-B frequency inverter system.
Ethernet TCP/IP
UDP
PROFIBUS DP-V1
DeviceNet
Ethernet TCP/IP
UDP, PROFINET
EtherNet/IP™
Modbus TCP/IP
DFP21B/UOH
DFD11B/UOH
DFE32B/UOH
DFE33B/UOH
DFE33B/UOH
DFE24B/UOH
Addendum to the Operating Instructions – MGF..-DSM
Configuration
stations
16
16
Number of stations
8
3
15