Table of Contents
Advertisement
3.1 Endowment and unpacking
The machine is supply with:
1 x Basic Unit X-Rot e-Power
1 x Radio Control
2 x Lithium battery for Radio control
1 x Battery charger
1 x Radio control's hanging belt
1 x User Manual & Engine user manual
1 x wrench kit (for crawler replacement)
Before operating the machine, check the fuel and engine oil levels and carefully read the
operating instructions for safety regulations and procedures for starting and controlling
the machine.
3.2 PRELIMINARY TESTS
Before to use the machine for the first time, it is necessary to verify:
• Battery charge (see Cap. 7.1.1)
• Battery charge on the Radio receiver (see Cap. 7.1.3)
- The 2 battery set have to be charged before to start any work. One battery should be
enough for one day operation but the 2nd one is required in case of need.
4.1 NAME OF MAJOR COMPONENTS
Identification of the main service plugs.(Fig.7a)
16
3 - MACHINE PREPARATION
Fig. 6
C
SECTION 3 - MACHINE PREPARATION
A
A) Comm. plug for Motor-Drivers
B) Brake release - Emergency plugs
B
C) Comm.plug RS232 for Logic card
D) Access point for 3 CANBUS lines
D
Fig. 7a
A - INTRODUZIONE
Advertisement
Table of Contents
