Table of Contents
Advertisement
7.2.8 Battery and remote control
The radio transmitter is supplied with 2 Li-MH batteries. Even if one battery is enough for
a day, it is recommended to charge both batteries before starting work. A battery charger
is supplied with the radio control to charge the battery.
Charger technical data
• Power supply voltage
• Power demand
• Charging current
• Battery
• Max. charging time
• Type of charge
• Casing protection degree
• Operating t° (charge)
7.3 Software update (ref. Fig.7a)
The Machine is equipped by 3 plugs for software update and system diagnostic.
Inside the cabinet there are the following connections:
- Molex Minifit 4poles for connection with motors
controllers (drive and PTO )
- Deutsch DTM 6 poles for connection with logic
card via RS232
- Deutsch DTM 8 poles for connection to the 3
CANBUS (Radio control, Drivers, Battery BMS)
42
7 - MAINTENANCE
230V AC
35mA AC/250mA
DC (during charge)
650mA
Ni-MH 3.6V 1.7 A/h
3 hours
PVD
IP30
0°C ÷ +35°C
SEZIONE 7 - MAINTENANCE
A - INTRODUZIONE
6203705
Fig. 33
6208059
Advertisement
Table of Contents
