Mounting Instructions
TX232TH-LCD Temperature/Humidity Sensor
Option 1:
Install one mounting screw into a
•
wall leaving some extended.
Place the transmitter onto the screw,
•
gently pull the transmitter down to
lock the screw into place.
Option 2:
Insert the mounting screw through
•
the front of the transmitter and into
the wall.
Tighten the screw to snug (do not
•
over tighten).
Mount the temperature/humidity sensor on
•
a north-facing wall or in any well shaded
location. Sun will make it read high.
Under an eave or deck rail is preferred.
•
Be sure the outdoor sensor is mounted
•
vertically to drain moisture.
Avoid mounting under a metal roof and use
•
stainless steel screws for best WWVB
reception and RF transmission.
The maximum wireless transmission
•
range to the weather station is over
330 feet (100 meters) in open air, not
including walls or floors.
TX231RW Multi-sensor
For most accurate wind speed and rainfall
•
readings, mount the Multi-sensor in an
open area clear for 50 feet in all directions.
Mount with the solar panel facing south so
•
the wind direction is correct. See N, S, E W,
embossed on the top of the sensor.
Use the bubble level on the top of the
•
sensor to ensure it is level, for accurate
rainfall readings.
328-2314
www.lacrossetechnology.com/support
Bubble
Level
Page | 6