What Are The Power Requirements For This Station; Setup And Mounting; Installing Wind Cups If Needed; Setup: How Do I Set Up My Station - La Crosse Technology 328-1415 Faq

WHAT ARE THE POWER REQUIREMENTS FOR THIS STATION?

TX145WSDR (Cyclone): 3 "AA" batteries
TX141TH-Bv4: 2 "AA" batteries.
328-1415: 5-volt power cord (required) and CR2032 batteries for backup of your time and date.
Battery operation only will not update sensor or Wi-Fi data. A power cord is required.
Depending on how your station is packaged, you may need to install your Wind Cups onto your
Cyclone sensor.
2. Remove the Cyclone Sensor, Wind Cups, and Mini
Screwdriver from the package. Take note of the flat
edges located on the head of the Cyclone Sensor
and underside of the Wind Cups.
3. Carefully tighten the screw on the side of the cups
using the Mini Screwdriver. The screw should
tighten into the flat edge of the post.
Thermo-Hygro Sensor: Install 2 fresh "AA" batteries according to polarity and replace the
battery cover. The red LED light will flash when transmitting.
Cyclone Sensor: Install 3 fresh "AA" batteries according to polarity and replace the battery
cover.

SETUP AND MOUNTING

INSTALLING WIND CUPS IF NEEDED

SETUP: HOW DO I SET UP MY STATION?

1. Align the flat edges and place the Wind Cups on top
of the Cyclone Sensor.
4. When the screw is tight, gently pull up on the cups
to ensure they are secure. If they pull off, start
again with step two.
3 | P a g e