Table of Contents
Advertisement
•
As humidity increases, the body is unable to cool effectively.
•
The temperature will feel warmer.
View Heat Index: From the default time display, press the TEMP button once and the Heat Index
will show instead of the outdoor ambient temperature.
Note: The heat index will be the same number as the temperature until the outdoor temperature is
above 26.7°C (80°F).
Dew Point Temperature:
•
Dew Point Temperature is the saturation point of the air, or the temperature to which the air
has to cool to create condensation.
•
The higher the dew points, the higher the moisture content of the air at a given
temperature.
View Dew Point Temperature: From the default time display, press the TEMP button twice and
Dew Point will show instead of the outdoor ambient temperature. The words "Dew Point" will show
near outdoor temperatures.
Note: Dew Point is lower than the actual temperature.
Channels
Explanation: The forecast station will accommodate up to three remote
channel selection + (PLUS) button on the forecast station allows you to see the temperature in
various locations: outdoors, baby's room, greenhouse, basement, etc.
•
Press and release the + (PLUS) button to view channels 1, 2, or 3 on the display when
multiple transmitters are used.
Note: You cannot change channels if only one transmitter is connected.
Multiple Outdoor Transmitters
To connect multiple remote transmitters to the forecast station:
•
Remove the battery cover from all the transmitters (leave off for setup).
•
Set the first outdoor transmitter to channel 1 and insert 2 AA batteries.
•
Set the second outdoor transmitter to channel 2 and insert 2 AA batteries.
•
Set the third outdoor transmitter to channel 3 and insert 2 AA batteries.
•
Press and hold the + (PLUS) button on the forecast station for 5-10 seconds.
•
The forecast station will search for all outdoor transmitters.
•
Press the TX button on the back of each outdoor transmitter to transmit an RF signal.
•
When RF (radio frequency) connection is established, the respective temperature &
humidity of the selected channels will appear on the main unit.
•
Allow the transmitters and the forecast station to stay 5-10 feet apart for 15 minutes to
establish a solid connection.
•
Install the battery covers on each sensor.
•
After 15 minutes, place the remote transmitters in appropriate locations within range of the
display.
•
Press and release the + (PLUS) button to view channels 1, 2, or 3 on the display when
multiple transmitters are used.
Mounting/Positioning Outdoor sensor
La Crosse Technology, Ltd.
www.lacrossetechnology.com/support
outdoor
transmitters. The
Page 7
Advertisement
Table of Contents
