Chapter 3. Configuration
Configuration Selections for DSX-1 Interfaces
The configuration selections listed in Table 3-3 are available for
Quad DSX-1 interfaces. Separate selections can be made for each of
the four DSX-1 ports of the card. The menu is shown in Figure 3-5.
Figure 3-5. Port Configuration Menu for Quad DSX-1 Interface Card
The Quad DSX-1 does not perform ESF to SF (D4) conversion through
the network. Therefore, both ends of the circuit must be configured for the
same framing type.
S
ELECTION
I
T
NTERFACE
YPE
P
S
ORT
TATUS
U
75
NALLOCATED
K
B
LOCKS
P
S
ORT
TATE
3-8
Table 3-3. DSX-1 Interface Port Configuration Selections
D
ESCRIPTION
This read-only status field displays
Quad DSX-1 interface card is installed in the DTE Port card slot.
This read-only status field displays
E
N
I
, or
RROR
OT
NSTALLED
1 interface.
Displays the amount of bandwidth (in 75k increments) not already
allocated to any of the OSU 300 DTE ports.
If an individual DSX-1 interface is installed but not currently in use, set
D
E
to
. Set to
ISABLED
OSU 300 User Manual
Q
DSX-1
UAD
I
,
NACTIVE
, indicating the current status of the DSX-
to activate a port.
NABLED
, indicating that a
A
W
,
,
CTIVE
AITING
61200663L1-1