Sharp AR-280 Service Manual page 113

Hide thumbs Also See for AR-280:
Table of Contents

Advertisement

AR-405
This simulation is used to automatically adjust the image loss, the void area, and the image position by directly entering
the paper lead edge and the image shift (in the unit of 0.1mm) in 400% (200% for the SPF) copy.
a. Distance (Document table mode 400%) up to the scale of 10mm from the image lead edge a L3
b. Distance from the paper lead edge to the image lead edge → L2
c. Distance from the image lead edge to the scale of 10mm (SPF mode 200%) → L3
* The measurement value is multiplied with 10 to enter.
With the above procedure, the values of RRC-A and RRC-B in SIM 50-1 are automatically calculated and set.By directly
setting the values (actual dimensions [mm] x 10) of IMAGE LOSS, DEN-A and DEN-B, the lead edge image loss, the lead
edge void area, and the rear edge void area can be set.
By setting the image loss, DEN-A, DEN-B (actual dimension (mm) x 10) and REAR LOSS (SPF) (actual dimension (mm))
directly, the lead edge image loss, the lead edge void area, the rear edge void area and the rear edge image loss (SPF)
can be set.
A
B
C
D
E
F
G
Note
1/21/1999
Code
Adjustment item
Distance between the image
L1
lead edge and the scale of
10mm.
Distance between the paper
L2
lead edge and the image lead
edge.
Distance between the image
L3
lead edge and the scale of
10mm (SPF mode).
IMAGE LOSS
Lead edge image loss
DEN-A
Lead edge void area
DEN-B
Rear edge void area
Rear edge image loss (SPF
REAR LOSS (SPF)
mode)
Adjustment value
1.5 to 3.0mm
1.5 to 3.0mm
1.5 to 3.0mm
8 – 68
Note
When the image lead edge
position varied depending on
the copy magnification ratio,
change the set value.
When the image lead edge
position varied depending on
the copy magnification ratio,
change the set value.
The greater the set value is,
the greater the image loss is.
The greater the set value is,
the greater the void area is.
The greater the set value is,
the greater the void area is.
The greater the set value is,
the greater the image loss is.
(AR-2X1/3X1/4XX/250/XX6
series only)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ar-285Ar-335Ar-405

Table of Contents