Sharp AR-280 Service Manual page 105

AR-405
Default: 100
Note
46 - 12 Purpose Adjustment
Function Used to adjust the print density in the FAXmode (all modes).
(Purpose) The print densities in all the modes (all the specified levels set for all the density levels (display values)) can be
collectively adjusted. (Same as SIM 46-13A.) (FAX model only)
Section
Item Picture quality
Operation/ 1. Select the print mode with [↑], [↓] key.
Procedure (The set value is highlighted.)
2. Enter the adjustment value wit the 10-key.
3. Press the [OK] key or the PRINT button. (The value entered in procedure 1 is set.) When the PRINT button is
pressed, copying is performed.
When the adjustment value is changed, the print density in the other modes (All FAX modes) is similarly changed.
(The set values of SIM 46-13 to -16 are changed accordingly.)
Normally the print density adjustment in the FAX mode is made with this simulation.
To make the print density adjustment in each mode, use SIM 46-13 to 46-16.)
(Note) When the set value in the left column of the table below is changed with this simulation, the set value (overall
(FAXmode)
Parameter set/changed by
Normal character mode
Small charater mode
Fine mode
Super fine mode
Default: 100
Note
1/21/1999
density level adjustment value) in the right column is also changed accordingly.
The parameters in the right and the left columns and the adjustment items are the adjustment values in the same
print mode.
The result of the adjustment set by the last simulation is applied to the actual print. Normally SIM 46-12 is used to
adjust the print density. To customize the print density for the density level display according to the user's request,
the simulation in the right column is used.
Linked simulation data
SIM 46-12
Sim 46-13
Sim 46-14
Sim 46-15
Sim 46-16
Density
8 – 60