Honeywell NOTIFIER FireWarden-100-2 Instruction Manual page 79

Master Programming Level
characters in the first screen, press Enter to view the second screen. Enter up to 20 characters in the
second screen in the same manner or just press Enter if a second banner line is not being entered.
To quickly clear the current banner, press the CLR key.
To enter alphanumeric characters from the keypad, repeatedly press the appropriate key until the
desired character is displayed in the first position. For example, to enter the letter B, press the 2
(ABC) key three times to toggle through the characters 1, A and B. Press the right arrow key to
move the cursor one position to the right and repeat the process to enter the next character. To enter
a space, press the * (QZ) key four times to place a blank in the desired position. When all
characters have been entered, press the Enter key to store the information. The display will return
to the Banner Screen.
Time-Date
The control panel time and date can be changed by pressing 3 while viewing the System Setup
SYSTEM SETUP
Screen #1. The following screen will be displayed:
1=TROUBLE REM
2=BANNER
3=TIME-DATE
System Setup Screen #1
To change the time, press 1 while viewing the Time-Date Screen. The following screen will be
displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is the current time.
To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor will
move one position to the right each time a digit is entered. After the last minutes digit is entered,
the cursor will again move one position to the right. At this point enter 1 for AM or 2 for PM. The
display will then return to the Time-Date Screen which will show the new time entry. If an error is
made while entering a digit, press the CLR key to delete the entire entry and beginning again.
FireWarden 100-2/E — P/N 52778:A 11/04/2005
1=TIME
2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
Time
10:00 AM
1=AM
TIME AND DATE
10:00 AM
04-07-2002
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
ENTER TIME
Time Screen
12HR
2=PM
Programming
79