Table of Contents
Advertisement
Master Programming Level
Description
EDIT CONTROL
1=ADJECTIVE/NOUN
The Description selection allows the programmer to enter additional information about the control
2=DESCRIPTION
module currently being programmed. This information will be displayed as part of the device label
on the display. Pressing 2 while viewing Edit Control Screen #4 will cause the following screen to
Edit Control Screen #4
be displayed:
A flashing cursor will appear at the first asterisk to the left. The programmer can enter additional
descriptive information about the device being programmed. This information will appear on the
display along with the standard device label information.
A maximum of 20 characters (including spaces) can be entered. To enter alphanumeric characters
from the keypad, repeatedly press the appropriate key until the desired character is displayed in the
first position. For example, to enter the letter B, press the 2 (ABC) key three times to toggle
through the characters 1, A and B. Press the right arrow key to move the cursor one position to the
right and repeat the process to enter the next character. To enter a space, press the * (QZ) key four
times until a blank appears in the desired position. When all characters have been entered, press the
Enter key to store the information. The display will return to the Edit Control Screen #4, displaying
the new information at the bottom of the screen.
Recall/Increment Function
In addition, the user may use the Recall/Increment function at any time when the cursor is on the
first letter of the Adjective or Noun field as follows:
As an example, the user could quickly enter 'FLR_3_ROOM 305' as follows:
1.
2.
3.
4.
5.
FireWarden 100-2/E — P/N 52778:A 11/04/2005
DESCRIPTION
1=NOUN/ADJECTIVE
********************
• If the zero key is pressed, a 0 is placed in the first letter position
• If the zero key is then pressed a second time with no intervening key actions, the entire
Adjective field is replaced with the field entered for the previous device programmed, and
the cursor moves to the last character of the field (Recall function). The Recalled Adjective
or Noun field may now be changed letter-by-letter
• If the zero key is pressed again with no other intervening key actions and the last character
in the field is a number 0-9, the number is incremented by one. If the last character is a
letter, it changes to a 0. If the last character goes from 9 to 0 and the characters to the left of
the last character are also numbers, they are also incremented (overflow)
• The above increment function may be repeated with each press of the zero key
The cursor is on the first letter of the Adjective field. Press the zero key twice to display
FLR_3
With the cursor on the first letter of the Noun field, press the zero key twice to recall the
display ROOM_304. The cursor automatically jumps from the first to the last letter of the
Noun field
With the cursor on the last letter of the Noun field, press the zero key again to increment the
room number to 305
Press the right arrow key to advance the zone field
Select a zone number from 00 to 99. Z00 (default zone) is the general alarm zone. Z01
through Z99 may be selected to link software zones
1M002
Adjective/Noun Screen
Programming
71
Advertisement
Table of Contents
