5-1-6. Setting of touch sensor radius (LH51 only)
• After completing 5-1-4 , press the x-axis selector key for the Touch sensor radius setting mode.
• Number keys and
• The touch sensor radius is factory set to 5.0000 mm.
• Correct setting of the touch sensor radius makes correct display of the reference point or
• In the example below, the resolution is set to 0.0005 mm.
The touch sensor radius setting can only be made for the input to the first axis.
Example
Example: Setting the radius to 10 mm
X
1
0
P
key are used to set and change the touch sensor radius.
measuring range possible in the load or hold operation with the touch sensor.
Note
Operating Procedure
Select the input to the first axis.
Press the number keys.
Press the Preset key to complete the setting.
Display
(Displayed for approx. 1 second)
19