Operation; Initial Settings - Sony Magnescale LH51 Instruction Manual

5. Operation

Cautions on Operation
1) When a malfunction occurs, characters as shown in "8. Alarm Display" on page 66 are
2) If two or more operation keys are pressed simultaneously, a malfunction may be caused.
3) Make sure that the least significant digit of an entered value agrees with the selected

5-1. Initial Settings

Before staring the operation, make the following initial settings:
• Items marked with a dash (––) indicate unnecessary initial settings for the respective model.
• Skip unnecessary initial settings by pressing an Axis selector key, and proceed to the next
• By pressing the
• The initial settings, once made, are stored even if the power is turned off. Therefore the initial
displayed in place of numerals.When the alarm display appears, press the
relevant axis and repeat the operation.
resolution.
5-1-1. Setting the resolution and polarity
5-1-2. Setting the minimum display unit
5-1-3. Setting the linear compensation
5-1-4. Setting the distance from the absolute zero point of the scale
to the cutting datum point
5-1-5. Absolute zero point clear control
5-1-6. Setting of touch sensor radius (LH51 only)
5-1-7. Setting of addition display mode (LH52 only)
5-1-8. Selection of absolute zero point of scale (LH52 only)
5-1-9. Setting inch/mm switching
These items are automatically canceled and cannot be selected. Items marked with a circle (\)
indicate the required initial settings for the respective model.
setting. After all the initial settings are completed, press the
displayed before the power was turned off is displayed, and the unit is switched to the
measurement mode.
key at any time during initial setting, the value that was displayed before
the power was turned off is displayed, and the unit is switched to the measurement mode.
settings are necessary only when the system is newly installed or when any setting revision is
required.
Initial setting item
key for the
Model
LH51 LH52
\ \
\ \
\ \
\ \
\ \
\ ––
–– \
–– \
\ \
key. The value that was
11